\\r\\n
2 in a room, double ended carburettor removal tool. One end for sh20 and the other for sh22.. Carb not...
Clutch spring aligning tool BGM superstrong clutches.
BGM "O" ring removal tool that can also be used for scribing ....
BGM Superstrong clutch compressing tool to be used with part number TLM8011TL2
The 4 way engine mount tool will fit direct to your flywheel and in most cases can be used without you...
Extractor tool for removing the CasaCooler bearing support bush X218..
Bridge bracket used to fit a dial gauge when you are setting up your front sprocket to the rear sprocket...
Clutch Compressor, for series 1,2 & 3. This mounts across 2 studs on the crankcase side, so it lines...
Clutch Compressor, for series 1,2 & 3. made un the UK
BGM Clutch holding tool that Holds the inner and outer clutch bell/housing so that the clutch nut can...
Powermaster clutch Special holding tool for holding the PowerMaster STD (art. X33s) clutch in place for...
Clutch spring aligning tool for when fitting clutches. This is for standard type clutches NOT BGM Su...
Crank shaft extracting tool. Made by Mb.. instructions: The tool is bolted on the crankcase side, fit...
Tool one for pulling crankshafts into place for for ALL Lambretta S1 + S2 + S3 + GP DL + Serveta's models....
Crank fitting/pulling tool Fit the tool over the crank on the drive side side and then use your drive...
Dial Gauge bracket, this bracket sits on top of the cylinder to hold a DTI gauge to set TDC... made by...
12 x 1mm Left hand fine thread for crankshaft flywheel side threads.
8 x 1mm right hand thread fine pitch for crankshaft drive side bolt threads series 1,2,3 & Gp
Digital multimeter -CTM-REV "Check-202" 2V - 250V- with rubber holster, and sound buzzer when testing...
Drive side bearing tool, tool to drift in the main driveside bearing.. MB scooters
This sleeve is used with the Mb crankshaft extracting tool so It can be used to pull the drive side bearing...
Drive side bearing fitting and removal tool. Use one way and the tool easily pushes out the bearing....
Drive side crankshaft dummy bearing bush tool. Stainless steel so it won t rust This replaces a flywheel...
Drive Sprocket Sleeve removing pulling tool. re-made by MB Scooters. Works on Series 1, 2 and 3 moto...
End plate bearing drift for fitting the bearing into the end plate . made by MB scooters
Jack for raising and supporting the engine when changing rear wheel....
Engine mount (silent block) removal & fitting tool.... BGM
Engine mount (silent block) removal & fitting tool. MB
Flywheel & clutch holding tool. Granturismo
Crankshaft inner bearing sleeve fitting tool.
Double sided flywheel Extractor/Puller for all Lambretta & Vespa models..
Flywheel holding tool that will hold 90% of Lambretta flywheels. It is double ended and will hold normal...
Flywheel Puller for all Italian and Electronic Lambretta Flywheels made in Italy