\\r\\n
Clutch arm O ring, this O ring sits on the chaincase where the clutch arm drops in .... its also used...
16mm wavy washer for the Engine bolt and rear shock.
MB mag housing stud, this stud fits in the engine case to secure the mag housing. can also be used for...
M6, Rear hub bearing stud for series 1,2,3 & Gp/Dl .. 4 required ....
Specially designed stud to be used as an upgrade on Race-Tour type cylinders to secure the head instead...
Dowel that locates the end plate to engine case and also locates the chain case to the main engine case,...
M6 grease nipple ..correct shape, 8 needed for series 1 & 2 models, 6 needed for series 3 models....
Woodruff Key....Good quality Italian made crank shaft key, fits in the slot to locate flywheel to the...
Xtra long (45mm) M6 crank case stud, Ideal for hanging exhausts to.
Rear hub plate stud, this stud tholds the rear hub bearing plate. can also be used to convert a gp gear...
Short inlet stud. 7 x 12-10-12 x 21mm in stainless steel made by MB..
1mm piston shim used on gudgeon pins to take up end float on standard pistons. 2 needed per piston.
L shaped washer sits inside your magneto housing and holds one of the oil seals in place....
4 slot head screws (standard Innocenti) that hold the drive side oil seal plate in place. These are the...
Engine bump stop washer..this fits underneath the bump stop rubber on the engine case.
Mag housing sealing plate Stud kit. The kit includes: 2 stainless steel studs. 2 nyloc nuts. 2 wavy ...
Rear hub bearing retaining plate shim, the thinner one .. S1, 2, 3 & Gp/Dl 858
6mm MB Stainless steel grease nipple, used on some Lambrettas on the front hub backplate, the fork links...
Engine side case fixing kit stainless steel.. contains: m6 Nut x 14 m8 Nut x 2 m6 Wavy Washer x 14 m8...
Engine circlip kit contains the correct circlips to overhaul an engine including stainless steel one...
Kickstart oil seal.. Fits all Series 1, 2 & 3 engines. Mb RaceTour brand..
Small mag oil seal.. Fits all Series 2 & 3 but not series 1 engines. Mb RaceTour brand..
Chain tensioner/slipper locking plate. This is used to spread the load from the two studs that hold the...
Engine side case fixing kit stainless steel.. contains: m6 Nyloc Nut x 14 m8 Nyloc Nut x 2 m6 Flat Washer...
Gear selector arm bush in brass that fits in the the engine case....
Side case oil level plug for series 1,2,3 and Gp/Dl as original.. Scootopia....
Rear hub oil seal.. Fits all Series 1, 2 and 3 . Mb RaceTour brand..
Chain tensioner lazer cut clamp plate & stud set This is used to hold the top chain slipper in place...
Mag housing stud and fixing set, these hold the mag house in place. made by MB..
Crankcase Breather/filler plug and fibre washer Casa B104