\\r\\n
Head light rim screw in Stainless steel. FITS: Series 3 Sx, Tv, Specials & Gp/Dl
Head light rim screw ZINK FITS: Series 3 Sx, Tv, Specials & Gp/Dl
Split pin in stainless steel for connecting petrol tap lever to the petrol tap and the rear brake pedal...
Rear hub nut wavy washer in stainless steel.... made by Mb..
Viton PH Choke/starter jet O ring. MB
Viton PH Choke/starter jet O ring. MB
MB stainless steel Headset top screw for series 1,3 and Gp/Dl as original... holds the headset top and...
MB Crankcase side stud, you need 14 for most crankcases. 6mm x 12 - 10 - 1mm in stainless steel, normal...
MB crankcase side stud,slightly longer that the standard crankcase stud by 4mm to allow the exhaust bracket...
Gear selector arm/tie bar Stainless steel E clip.
Extra long screw in stainless steel for fixing the inner front mudguard on series 1 & 2 Lambretta s.....
Mag sealing plate stud long nut in stainless steel...
8mm domed domed Stainless steel wheel nut.
MB mag housing stud, this stud fits in the engine case to secure the mag housing. can also be used for...
Mb rear hub bearing O ring seal.. fits in the recess in the bearing to form a better seal..
Exhaust stud for oval ports to suit the longer MB brass nuts.
Kickstart outer circlip in... This circlip uses extra tags which spread the load around the outer wa...
MB 5 x 12 Extended flywheel and cylinder cowling screws in stainless steel made with a longer hex to...
Rear mudguard Fixing kit for series 3 li,sx,tv & Gp in stainless steel..
MB longer exhaust port stud for round exhaust ports to suit the new longer stronger MB brass nuts.
Mb stainless steel shim fits on the gear pivot base beneath the swivel on standard type gear pivot bases....
These rubbers fit between the mount bracket and Regulators, Rectifiers or Regulator/Rectifier.. made...
0.5mm Handle bar rod shim that fits on the handle bar rod to take out any play....
1mm Shim that fits on the handle bar rod to take out any play....
Series 1 and 2 throttle tube wavy/dished washer in stainless steel. MB
Throttle dished washer for series 3 and Gp/Dl.
Stainless steel washer that sits in your fork link to hold your spindle (and hub) in place Two needed...
Viton PH Carb float bowl O ring. petrol resistant MB
Fork link 12mm half nut for fork link bolts, these are a finer pitch than the front wheel spindles and...
Stainless steel studs designed for use with cylinders with oval exhaust ports (eg standard, Mugello,...
MB Headlight rim screw in stainless steel 3 x 22mm with locating peg to make finding the thread in the...
Rear hub plate stud, this stud tholds the rear hub bearing plate. can also be used to convert a gp gear...
Rear Hub Cone Washer 1mm(0.9mm) Thick, in stainless steel.. made by MB
Sealing plate grommet on top of mag house where stator wires go through LARGE Type.
Short inlet stud. 7 x 12-10-12 x 21mm in stainless steel made by MB..
2mm Rear Hub Cone Washer/shim in stainless steel.. made by MB
Short inlet stud for RT cylinders in stainless steel. 7x34mm - 17x7x10mm, exhaust port, oval, RT inlet...