\\r\\n
Engine bump stop rubber & washer for series 2,3 &Gp/Dl....
MB relieved cylinder stud. Relieved between thread ends to fit some cylinders that haven t been drilled...
Mag housing wire kit includes Two steel sealing plates, a gasket, a rubber grommet and fasteners...
Crankcase Breather/filler plug and fibre washer Casa B104
Mag housing stud and fixing set, these hold the mag house in place. made by MB..
Rear hub oil seal.. Fits all Series 1, 2 and 3 . Mb RaceTour brand..
Double lipped oil seal in Viton for all versions of CasaCooler
Engine side case fixing kit stainless steel.. contains: m6 Nyloc Nut x 14 m8 Nyloc Nut x 2 m6 Flat Washer...
Chain tensioner/slipper locking plate. This is used to spread the load from the two studs that hold the...
Small mag oil seal.. Fits all Series 2 & 3 but not series 1 engines. Mb RaceTour brand..
Kickstart oil seal.. Fits all Series 1, 2 & 3 engines. Mb RaceTour brand..
Engine side case fixing kit stainless steel.. contains: m6 Nut x 14 m8 Nut x 2 m6 Wavy Washer x 14 m8...
6mm MB Stainless steel grease nipple, used on some Lambrettas on the front hub backplate, the fork links...
Rear hub bearing retaining plate shim, the thinner one .. S1, 2, 3 & Gp/Dl 858
Mag housing sealing plate Stud kit. The kit includes: 2 stainless steel studs. 2 nyloc nuts. 2 wavy ...
4 slot head screws (standard Innocenti) that hold the drive side oil seal plate in place. These are the...
Engine bump stop washer..this fits underneath the bump stop rubber on the engine case.
L shaped washer sits inside your magneto housing and holds one of the oil seals in place....
Mag house bearing spacer ring for li/lis/tv/sx bearings.
Piston circlips that are suitable for all Japanese style pistons (including Wiseco) with 16mm gudgeon...
1mm piston shim used on gudgeon pins to take up end float on standard pistons. 2 needed per piston.
Short inlet stud. 7 x 12-10-12 x 21mm in stainless steel made by MB..
Xtra long (45mm) M6 crank case stud, Ideal for hanging exhausts to.
Dowel that locates the end plate to engine case and also locates the chain case to the main engine case,...
4 screws that hold the drive side seal plate in place. I use these high tensile csk socket screws to...
M6 grease nipple ..correct shape, 8 needed for series 1 & 2 models, 6 needed for series 3 models....
Woodruff Key....Good quality Italian made crank shaft key, fits in the slot to locate flywheel to the...