\\r\\n
End plate bearing drift for fitting the bearing into the end plate . made by MB scooters
Tool for pulling the layshaft in. Offer the layshaft into the bearing, fit the sleeve locating the allen...
Flywheel holding tool that will hold 90% of Lambretta flywheels. It is double ended and will hold normal...
Crankshaft inner bearing sleeve fitting tool.
Dial Gauge bracket, this bracket sits on top of the cylinder to hold a DTI gauge to set TDC... made by...
Small mag oil seal tool to drift in the small magneto housing oil seal.. made by MB scooters
Bridge bracket used to fit a dial gauge when you are setting up your front sprocket to the rear sprocket...
Crank shaft extracting tool. Made by Mb.. instructions: The tool is bolted on the crankcase side, fit...
Steering bearing race fitting tool. for series 1, 2, 3 & Gp/Dl scooters. made by MB
Drive side bearing tool, tool to drift in the main driveside bearing.. MB scooters
Jack for raising and supporting the engine when changing rear wheel....
Drive side bearing fitting and removal tool. Use one way and the tool easily pushes out the bearing....
Rear hub bearing fitting and removal tool. Use one way and the tool easily pushes out the bearing and...
Mag side crankshaft dummy bearing bush tool. Stainless steel so it doesn t rust. This replaces a flywheel...
Drive side crankshaft dummy bearing bush tool. Stainless steel so it won t rust This replaces a flywheel...
Multi purpose 8mm T handle screws. These are very useful and they can be used all the time on an engine...
Double sided flywheel Extractor/Puller for all Lambretta & Vespa models..
Clutch spring aligning tool for when fitting clutches. This is for standard type clutches NOT BGM Su...
The 4 way engine mount tool will fit direct to your flywheel and in most cases can be used without you...
Jack for raising and supporting the engine when changing rear wheel....
Flywheel Puller for all Italian and Electronic Lambretta Flywheels made in Italy
Tap ratchet T handle for larger tap sizes. 5mm to 12mm tap sizes.
Spark plug spanner for Lambretta S1 + S2 + S3 + DL GP + J model.
Piston stop tool, universal for Lambretta & Vespa (short reach type)....
Vape ignition flywheel holding tool for all types of Lambretta Vape Ignition Systems
Disposable Nitrile gloves Engineers mate (best disposable gloves available) Features: Fish Scale Type...
Piston stop tool, universal for Lambretta & Vespa. Plastic ebd version.
Leak down kit for testing air leaks for Luna , Lui, Vega & J comes with exhaust blanking/sealing plate...
Flywheel & clutch holding tool. Granturismo
2 in a room, double ended carburettor removal tool. One end for sh20 and the other for sh22.. Carb not...
Tap ratchet T handle for smaller tap sizes. 3mm to 8mm tap sizes.
Digital multimeter -CTM-REV "Check-202" 2V - 250V- with rubber holster, and sound buzzer when testing...
Self powered Strobe timing light for setting ignition timing this uses its own battery to run it and...
BGM Clutch holding tool that Holds the inner and outer clutch bell/housing so that the clutch nut can...