\\r\\n
Quattrini 210 cylinder kit. Please note, you will require a 116mm length con rod crankshaft, to run this...
66mm (200cc)Cylinder Head 9.5:1 Compression.
TS1 cylinder kit with Asso piston 70mm BGM billet cylinder head....
70mm (225) Cylinder Head 9.5:1 Compression....
ST ST Magnetic drain, level & breather plug set with fibre washers. made by Gran Turismo
200cc Gp/Dl engine case Uni Bare case includes matched end plate and side studs
Side case oil level plug for series 1,2,3 and Gp/Dl as original.. Scootopia....
Cylinder head cowling in WHITE ... Original style LI/SX & TV cylinder cowl (also fitted to early DL/GP...
Gp/Dl Cylinder head cowling in WHITE ... With fixed internal plate (can be fitted at all lambretta models...
Engine Bar Nuts & Wavy Washer Set in stainless steal..
Engine side case fixing kit stainless steel.. contains: m6 Nut x 14 m8 Nut x 2 m6 Wavy Washer x 14 m8...
M6, Rear hub bearing stud for series 1,2,3 & Gp/Dl .. 4 required ....
Dowel that locates the end plate to engine case and also locates the chain case to the main engine case,...
TS1 225cc cylinder kit with Asso Piston including 70mm AF skimmed head (9.5:1 compression)....
Xtra long (45mm) M6 crank case stud, Ideal for hanging exhausts to.
4 slot head screws (standard Innocenti) that hold the drive side oil seal plate in place. These are the...
Gp 58mm stroke 107mm conrod Road/Race crankshaft, with shimmed conrod made in Italy, teflon coated, high...
Magnetic drain, level & breather plug set with fibre washers..
Chain tensioner lazer cut clamp plate & stud set This is used to hold the top chain slipper in place...
Flywheel cover in steel,black in colour . thinner type for standard length flywheel fins.
1mm piston shim used on gudgeon pins to take up end float on standard pistons. 2 needed per piston.
Engine bump stop rubber & washer for series 2,3 &Gp/Dl....
Clutch arm O ring, this O ring sits on the chaincase where the clutch arm drops in .... its also used...
L shaped washer sits inside your magneto housing and holds one of the oil seals in place....
Cylinder stud & extended nut set the stards are made in high tensile steel Longer than standard M8 x...
160mm Cylinder stud set, made in high tensile steel Longer than standard M8 25 - 110 - 25
Woodruff Key....Good quality Italian made crank shaft key, fits in the slot to locate flywheel to the...
Rear hub bearing retaining plates....inner & outer ....
Scootopia 3 Hole engine mounts (silent blocks) very high quality made by Scootopia ..sold in pairs.....
M6 grease nipple ..correct shape, 8 needed for series 1 & 2 models, 6 needed for series 3 models....
Mag housing sealing plate Stud kit. The kit includes: 2 stainless steel studs. 2 nyloc nuts. 2 wavy ...