\\r\\n
Clutch arm O ring, this O ring sits on the chaincase where the clutch arm drops in .... its also used...
L shaped washer sits inside your magneto housing and holds one of the oil seals in place....
16mm wavy washer for the Engine bolt and rear shock.
Woodruff Key....Good quality Italian made crank shaft key, fits in the slot to locate flywheel to the...
4 screws that hold the drive side seal plate in place. I use these high tensile csk socket screws to...
M6 grease nipple ..correct shape, 8 needed for series 1 & 2 models, 6 needed for series 3 models....
Dowel that locates the end plate to engine case and also locates the chain case to the main engine case,...
4 slot head screws (standard Innocenti) that hold the drive side oil seal plate in place. These are the...
Mag housing wire kit includes Two steel sealing plates, a gasket, a rubber grommet and fasteners...
MB mag housing stud, this stud fits in the engine case to secure the mag housing. can also be used for...
Rear hub plate stud, this stud tholds the rear hub bearing plate. can also be used to convert a gp gear...
Short inlet stud. 7 x 12-10-12 x 21mm in stainless steel made by MB..
6mm MB Stainless steel grease nipple, used on some Lambrettas on the front hub backplate, the fork links...
BGM Engine mounts sold in pairs,these fit all Lambretta engine casings - Series I, 2, 3 and Gp/Dl. Marked...
Bare mag housing, New UNI .. fits li/sx/tv/Gp and can be used on Series 1 & 2... .
Double lipped oil seal in Viton for all versions of CasaCooler
1mm piston shim used on gudgeon pins to take up end float on standard pistons. 2 needed per piston.
Small mag oil seal.. Fits all Series 2 & 3 but not series 1 engines. Mb RaceTour brand..
MB crankcase side stud,slightly longer that the standard crankcase stud by 4mm to allow the exhaust bracket...
Mag sealing plate stud long nut in stainless steel...
Engine bump stop washer..this fits underneath the bump stop rubber on the engine case.
Kickstart oil seal.. Fits all Series 1, 2 & 3 engines. Mb RaceTour brand..
M6, Rear hub bearing stud for series 1,2,3 & Gp/Dl .. 4 required ....
Cylinder head distance spacer nut and washer kit.
MB drive side oil seal plate including allen type fixing screws.
Engine bump stop rubber & washer for series 2,3 &Gp/Dl....
This is the 'SuperSeal' drive side oilseal aluminium retainer plate for all Lambretta S1 + S2 + S3 +...
Mag housing sealing plate Stud kit. The kit includes: 2 stainless steel studs. 2 nyloc nuts. 2 wavy ...
Xtra long (45mm) M6 crank case stud, Ideal for hanging exhausts to.